Command Parking Sensor Front Kit

The 91CMD05-4F Command Front Parking Sensor System aids in the detection of obstructions in front of your vehicle.

As this kit is designed for front fitment, power is not taken from the reverse lamp power feed and rather taken from ignition with both brake pedal activation as well as offering a manual activation/deactivation button for added safety.

After applying the brake pedal the system will activate and remain active for 15 seconds.

If an obstruction is detected during this period the timer restarts for another 15 second cycle.

If an obstruction is not detected the system reverts to stand-by mode.

All 4 sensors must be fitted to vehicle.

Obstruction Warning Guide:
0.7m - Slow warning beep and red indicator light as distance decreases.
0.3m - Rapid warning beep and red indicator light as distance decreases.

Sensitivity Adjustment:
Adjustments that can be made to reduce sensor sensitivity levels.

The final (rapid) warning stage can be set at 0.3 or 0.5 meters via a switch on the Digital Control Module.

The volume of the warning signal and detection distance can also be adjusted via a switch on the Digital Control Module.

Sensor fitment: Flush mount
Sensor colour: Black - paintable
Sensor size: 25mm outer, 21mm inner (21mm deep)
Warning type: Audible buzzer with flashing lights - brake light activation with 15sec shutdown delay
Detecting range: 0.2-0.7m adjustable to 0.3-0.5m
Sensor adjustment: Yes - DIP switch
Volume adjustment: Yes - adjustable high/low
Ingress protection: Sensor IP67, module none
Connector type: Screw type to small 2 pin
Frequency: 40KHz
Power supply: 9 - 16v
Lead length: 4.8m (sensor to module)
Pack Includes: 4 x black flush mount sensors, 1 x CMDO5 front sensor module, 1 x buzzer, power harness, 21mm hole saw, 3M sticky backed Velcro, cable ties, manual activation switch.